Pt 40 Flexx Bodypack Transmitter; Controls - AKG PT40 PRO Modo De Empleo

PT 40_2008_Hex:Layout 1
2.5 PT 40 FLEXX
Bodypack Transmitter

2.5.1 Controls

18
01/17/2008 09:52
2 Description
7 Viewing window: The viewing window lets you check if there is a dry or rechargeable bat-
tery inside the battery compartment. You can also insert a white lettering strip (supplied)
or a color code strip (optional) into the viewing window.
8 GAIN: This rotary control inside the battery compartment allows you to match the body-
pack transmitter input gain to the microphone or instrument you connected to the trans-
mitter.
9 Carrier frequency label: The label on the transmitter rear panel indicates the carrier fre-
quency, color code (receiver channels with the same carrier frequency are marked with
the same color), and approv al marks of your transmitter. Refer to the Manual Supplement
sheet for a color code table.
Operating in the 660 MHz to 865 MHz UHF range, the PT 40 FLEXX provides three selectable,
quartz stabilized carrier frequencies within the 3-MHz-wide frequency band for which you ordered
your WMS 40 FLEXX.
You can use the PT 40 FLEXX bodypack transmitter with both dynamic microphones and con-
denser microphones designed for a supply voltage of approx. 4 V. You may also connect an
electric guitar, electric bass, or remote keyboard.
Note: • If you use a rechargeable battery, the LED will change to red 15 minutes before the bat-
tery will be dead!
3 Audio input: 3-pin mini XLR connector with both mic and line level pins that automat-
ically match the connector pinout of the recommended AKG microphones or MKG L gui-
tar cable.
4 Frequency selector: This slide switch tunes the transmitter to one of three different
carrier frequencies within the transmitter's carrier frequency band.
5 Antenna: Permanently connected, flexible antenna.
6 Belt clip for fixing the transmitter to your belt.
7 Battery compartment lid with integrated screwdriver.
8 Viewing window: The viewing window lets you check if there is a dry or rechargeable
battery inside the battery compartment. You can also place a white lettering strip (sup-
plied) or a color code strip (optional) behind the viewing window.
Seite 18 (Schwarz/Black Auszug)
1 On/off switch: This slide switch
provides three positions:
ON: Power to the transmitter is
on.
MUTE: The signal delivered by
the microphone element is muted
while power and the RF carrier
frequency remain on.
OFF: Power to the transmitter is
off.
2 Status LED: Indicates the trans-
mitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment
10
the LED changes to red, the bat-
tery capacity will provide a maxi-
mum of two operating hours. We
recommend replacing the battery
with a new one as soon as possi-
ble.
PT 40 PRO/FLEXX