The Fountainhead Group Backpack Sprayer Manual De Uso Y Cuidado página 3

Assemble Extension, Shut-Off, Nozzle and Spray
Optimizer
1. Install the extension "wand" onto the shut-off
assembly and tighten the nut securely. (See Figure A)
2. (Optional) Install Spray Optimizer for low pressure (low
drift) applications. This will help prevent weed killer
formulas from drifting into undesired areas. (Do not
over tighten, actual position will vary. See Figure B)
3. Install selected nozzle onto the end of the extension
or optimizer (if installed) and tighten securely.
(See Figure C)
SELECT USING NOZZLE CHART BELOW
(Nozzle selections vary by model)
E
D
C
A
G
B
F
H
A. Cap Nut
B. Foaming Nozzle
C. Red High-Volume Fan Nozzle
D. Yellow Low-Volume Fan Nozzle
E. Adjustable Cone Nozzle
F. Flat Seal
G. Adapter
H. Extension
Assemble Pump Handle
Slide handle onto shaft and line up holes. Thread bolt through handle
and shaft and securely tighten. Thread on lock nut and tighten using a
13mm (or adjustable) wrench. Handle can be mounted on left or right
depending on user preference. (See Figure D)
Always conduct a test using cool, clean water before mixing chemicals.
Filling
Always refer to chemical manufacturer for proper mixture.
1. Remove the cap from the tank.
2. Make sure the filter basket is in place in the neck of the tank. The filter
basket includes the seal and must be in place to prevent leaks.
3. Fill the tank with cool water and chemical to the desired level.
4. Reinstall the cap.
Pressurizing and Spraying
1. To begin pressurizing, be sure shut-off lever is not depressed. Pump handle
up and down in a smooth motion (See Figure E). Operating pressure is
reached when pumping becomes difficult, which is no more than
4-6 full pumps. (Do not over-pressurize)
2. Direct nozzle away from you and squeeze shut-off lever to begin spraying.
ASSEMBLY INSTRUCTIONS
ADJUSTABLE CONE USES:
Spot spraying in or around flower
beds, trees, and shrubs.
Edging along fences, driveways,
and walkways.
Killing brush such as poison ivy,
poison oak, kudzu and wild
blackberry.
Preparing garden beds for planting
of ornamentals and vegetables.
RED HIGH VOLUME
FAN NOZZLE USES:
Lawn replacement. Kill lawn and
weeds before planting a new lawn.
Preparing large areas for planting
of ornamental and vegetable
gardens.
OPERATING INSTRUCTIONS
Figure B
(Optional)
Figure A
FOAMING NOZZLE USES:
Spot spraying in flower beds,
walkways, driveways, and patios,
around trees and shrubs.
Edging along fences, driveways and
walkways.
Killing brush such as poison ivy,
poison oak, kudzu and wild
blackberry.
YELLOW LOW VOLUME
FAN NOZZLE USES:
For precision spraying in confined
areas such as gardens and flower
beds.
Figure D
Figure E
Figure C
Page 3