Install The Bracket - Axis HOV Guia De Instalacion

AXIS HOV Housing VT
2

Install the bracket

Install the mount for the AXIS HOV Housing on a wall ceiling or pole and make sure that the screws
and plugs are appropriate for the material (e.g. wood, metal, sheet rock, stone). Check if the wall
A
bracket has an internal cable channel or
corresponding description below and install the wall bracket in the intended position.
A
Alt.
Wall bracket with internal cable channel
1. Install the wall bracket/holder on a wall, ceiling or pole using the appropriate screws for
the weight of the housing and the material.
2. Attach the rubber gasket and make holes for the cables.
3. Pull a sufficient length of the cables through for the housing and camera (approximately
50cm).
B
Alt.
Wall bracket with external cabling
Install the cables and wall bracket/holder on a wall, ceiling or pole. To comply with the
IP66-rated design of the AXIS HOV Housing, it is necessary to use appropriate conduits to
protect the cables.
rubber gasket
cables
A - Wall bracket (internal cable channel)
Note:
Please visit the Axis web site at www.axis.com for a comprehensive list of the available
brackets and accessories.
B
if the cables are routed separately. Select the
cables
B - Wall bracket (external cabling)
Page 5
cables