Install The Bracket - Axis T92A10 Guia De Instalacion

AXIS T92A10 Installation Guide

Install the bracket

2
Install the mount for AXIS T92A10 on a wall ceiling or pole and make sure the screws and plugs are
appropriate for the material (wood, metal, sheet rock, stone). Install the wall bracket as explained
below.
1. Install the wall bracket/holder on a wall,
ceiling or pole using screws appropriate for
the weight of the housing and the material.
2. Attach the rubber gasket and make holes for
the cables.
3. Pull a sufficient length of the cables
through for the housing and camera
(approximately 50cm, or 20 inches).
4. Proceed to "Install the camera in the
housing" on page 6.
rubber gasket
cables
A - Wall bracket (internal cable channel)
Page 5
cables