Wiring; Canopy Assembly - Ellington Elevating Style E-BLD52AN5C1 Guia De Instalacion

7. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground (GREEN or Bare) wire is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions,
please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be
made as follows:
Connect BLACK and BLUE wire from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from fan
to the BLACK supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote adaptable (remote control sold
separately).

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket to
determine which 2 screws align with slotted holes in
canopy, and then lower canopy and partially loosen these
2 screws. Remove the other 2 screws and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws and secure all screws with Phillips
screwdriver.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
slotted
hole
page 6
ground
(green or bare)
ground (green
or bare)
*
hanging bracket
canopy