Kettler SCHUBKARRE Manual De Instrucciones página 6

GB
■ Please bear in mind that children are very often not able to judge their own capabilities and
certain (dangerous) situations. Also consider that a natural urge to play plus their tempera-
ment may lead children into unforeseen situations for which the manufacturer cannot be held
responsible.
■ Please ensure that the wheelbarrow is only used in surroundings free of danger.
■ This wheelbarrow does not have lights. It is dangerous to use it in the dark.
Handling
■ Before use always check that all screws and plug-in connections and respective safety devi-
ces fit correctly.
■ Instruct children in the correct use of the product, and draw their attention to possible dan-
gers.
■ Sturdy, closed footwear must be worn when using this product.
■ Never load the wheelbarrow with more than the recommended weight (15 kg).
■ Distribute load evenly in the wheelbarrow to avoid danger of tipping over.
■ If this product can be adjusted please adapt it to your child's height.
■ Never use corrosive or abrasive substances to clean the toy. Never use substances which
may cause pollution of the environment.
■ Lubricate the bearing sleeves of the wheels with a few drops of oil every two or three months.
■ For models with pneumatic tyres: When leaving wheeled toys with pneumatic tyres on floors
containing solvents or which have been glued with such solvents (e.g. PVC) they may possi-
bly stain it due to a chemical reaction with the natural product caoutchouc. If in doubt place
something underneath the wheels. Ensure that air pressure in the tyres is correct (2,5 bar); if
air pressure is too low this increases wear, and makes riding the toy more difficult!
■ Max. total height of wheelbarrow: upper edge of body.
Assembly of the toy vehicle
■ The toy vehicle must be assembled carefully by an adult person. Study the assembly instruc-
tions carefully before beginning work. Assemble the vehicle in the exact sequence shown by
the letters in the diagrams. This is essential for the safe function and use of the toy vehicle.
■ Please note that there is always a danger of injury when working with tools or doing manu-
al work. Therefore please be careful when assembling this machine.
■ Bolt all the parts together loosely at first, and check that they have been assembled correct-
ly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts
completely against resistance (locking device). Then check that all screw connections have
been tightened firmly. Attention: once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be replaced.
■ When assembling plastic grips: The grips can be pushed onto the tubes more easily if they
are first soaked in warm water.
■ For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addi-
tion of tubing plugs).
6