Fcc Statement - HoMedics SHIATSU AIR 2.0 Manual Del Usaurio

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: HoMedics is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and CAN ICES-3 (B)/ NMB-3 (B). These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ROTATING MASSAGE NODES CONTROL PANEL
For tired soles and arches.
COMPRESSION MASSAGE
Compression massage deeply
squeezes feet in a rhythmic
wavelike motion.
KNEADING MASSAGE
Kneading massage simulates 2
hands pressing firmly and slowly,
traveling back and forth on the
soles of your feet.
REMOVABLE, WASHABLE INSERTS
Unzip the fabric to clean. See
care instructions on page 5.
INTEGRATED CORD MANAGEMENT
6
POWER BUTTON
To turn the massage function on, first press
the power button. The LED indicator will
illuminate white and confirm your selection.
To turn off the massage function, press the
button again.
KNEAD INTENSITY BUTTON
Choose low, medium, or high
kneading intensity.
HEAT BUTTON
For soothing heat, when the
massage is on, press the
"HEAT" button. To deselect,
press the "HEAT" button again
and the corresponding LED light
will turn off. For your safety,
heat can only be turned on when
massage is activated.
AIR INTENSITY BUTTON
Choose low, medium, or high
compression intensity.
MODE BUTTON
Activates air only, knead only,
or a combination of both.
7