Steamery Cirrus No.1 Manual página 5

Cirrus No.1 Steamer
Box Content
1. Cirrus No.1 Travel Steamer
2. Water Container
3. Fabric Brush
4. Measuring Cup
1
Operating Instructions
THIS STEAMER IS FOR HOUSEHOLD USE ONLY (for commercial use,
Steamery recommends our commercial steamer model Stratus No.2
Professional Steamer.)
5
3
4
2
Preparations
Remove the water container by pulling it in the opposite direction from
the nozzle and lift it out from the steamer. Take off the rubber plug on top
of the water container and fill it with distilled water as this will prevent
mineral deposits in the boiler that can reduce performance or clog the
water system. Close the water container with the rubber plug and put it
back in position in the steamer.
Using Your Cirrus No.1 Steamer
1. Turn on the steamer by putting the plug into a power outlet and
wait 20-25 seconds until red light turns off and the green light
comes on. This indicates that the steam has reached the right
temperature for use. Do not press the steam button before the
green light comes on.
2. While steaming, if the red light goes on, wait a few seconds
without pressing the button. The steam needs to reach the right
temperature again.
3. When using the device for the first time, test steaming first on
an old cloth as there might still be dry powder sediment left in
the steamer from the manufacturing process.
4. Steam your preferred garment by hanging it on a hanger and
move the nozzle over the fabric at the same time as you press
the steam button to spray steam on to the garment. Point the
steamer so the steam jets away from you. Do not use the
steamer for more than 30 minutes continuously. If you wish to
use your steamer for more than 30 minutes, let it cool off for
one hour in between uses.
6