Safety Precautions - golmar TEKNA 90 Manual De Instalación

INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers. To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
OPERATION
O
Call reception.
A call from the door panel will be received at the monitor in the apartment, lasting in 5 seconds: the picture will
appear on the master monitor without the visitor being aware of this; on the slave monitors (if exist), press the
'Video Spy' button
sound different, and the picture will appear if the porter's exchange has an optional camera configurated for
monitors use. If the call is not answered after 30 seconds, the channel will be freed.
To establish communication, pick up the monitor handset: communication lasts for one and a half minutes or
until the handset is replaced. The channel will be freed.
To open the door, press the door release button
press, the door release operates for approximately 4 seconds.
O
Calling to the porter's exchange.
To establish communication with the porter's exchange, pick up the handset and press the door release push
button ; if the porter's exchange has an optional camera configurated for monitors use, the picture will
appear on the monitor. Communication lasts for one and a half minutes, or until one of the handsets is
replaced.
O Autoswitch-on operation (only for chalet installations).
To establish communication with the door panel, without being called, pick up the handset and press the
autoswitch-on button
replaced.
O Call reception from the flat door bell push button (HZ).
This monitor allows the replacement of the door bell. When a call is received from the door push button, an
acoustic tone will be heard on the monitor, different that the produced when the call is done from the door
panel. If the call is done during communication progress, the on-off light indicator will blink.
O
Systems with optional devices.
To operate optional devices, the use of a SAR-12/24 is required for each one. To activate the device '2C'
nd
(2 camera), press the button
'A1', press the button

SAFETY PRECAUTIONS

O The installation and handling of the monitor must be performed by authorized personnel and in the
absence of electrical current.
O Do not use excessive force when tightening the monitor connection block screws.
O
The entire installation must be at least 40cm away from any other installation
O Install the monitor in a dry and protected place without risk of drip or water projections.
O Avoid placing the monitor near sources of heat, in dusty locations or smoky environments.
O Do not block ventilation holes of the unit so that air can circulate freely.
O
Before connecting the system's power supply, check the connections between door panel and monitor(s).
O Tekna 90 only replacement the SH-90 (cod. 11758902) and SH90 Col (cod. 11758952) monitors.
O
Do always follow the enclosed information
to see the picture. If the call has been made from the porter's exchange, the call will
; communication lasts for one and a half minutes, or until the monitor handset is
during call or communication progresses. To operate the optional device
at any time.
.
during call or communication progresses; with one
.
7