Epson IM-800 Manual Del Usuario página 10

English
Do not place multiple loads on the power outlet (wall outlet).
Overloading the outlet may lead to fire.
The equipment must be installed near the electrical outlet, and the
outlet must be easily accessible.
Do not attempt to open or disassemble the internal lithium battery. This
could result in burns or release of hazardous chemicals.
Do not charge the internal lithium battery or leave it in a hot place such
as near a fire or on a heater because it could overheat and ignite.
When you dispose of the internal lithium battery, insulate it by wrapping
the terminals with tape. Mixing the battery with other metals or batteries
may lead to fire, heat, or explosion.
Be sure your power cord meets the relevant safety standards and
includes a power system ground terminal (PE terminal).
There is a ventilation opening on the right side; do not place any object
in front of it. If you set this product upright, be sure the ventilation
opening is on the top. Do not place any object on top of the ventilation
opening.
Handle the power cord with care. Improper handling may lead to fire or
shock.
Do not modify or attempt to repair the cord.
Do not place any object on top of the cord.
Avoid excessive bending, twisting, and pulling of the cord.
Do not place the cord near heating equipment.
Check that the plug is clean before plugging it in.
Be sure to push the prongs all the way in.
Do not use a damaged cord.
Regularly remove the power plug from the outlet and clean the base of
the prongs and between the prongs. If you leave the power plug in the
outlet for a long time, dust may collect on the base of the prongs,
causing a short and fire.
CAUTION:
When replacing the battery, use only an equivalent type battery
recommended by the manufacturer. If your system has a module
containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not connect cables other than those specified in this manual. Doing
so may result in fire or improper operation.
Do not connect the unit to electrical outlets that are close to devices
that generate voltage fluctuations or electrical noise. In particular, stay
clear of devices that use large electric motors.
Always connect the power cable to the IM-800 before plugging it into
the wall outlet.
4 IM-800 User's Manual
All manuals and user guides at all-guides.com