Super Ego DRILL-71 Manual De Instrucciones página 17

The following table shows which position should be used:
Selector switch
Material
position
Impact Concrete,
drilling brick, stone
Wood, metal,
Drilling
Drilling
Drilling tile
- Set the drilling/impact drilling selector switch (4) on the Drill position and drill the hole.
- Set the drilling/impact drilling selector switch (4) on the position
Screwing in/loosening screws
- Set the drilling/impact drilling selector switch (4) to the position
- Choose the desired rotation direction (see Selecting the rotation direction)
- Use a low rotation speed.
Setting the rotation speed
- By pressing the on/off switch (9), you can set the rotation speed during idle operation. The optimal
rotation speed depends on the work piece, the operation mode, and the inserted drill.
- A light pressure on the on/off switch (9) means a low rotation speed (intended for small/short screws and
soft working materials)
- A greater pressure on the on/off switch (9) means a higher rotation speed (intended for large/long screws
and hard working materials).
Selecting the rotation direction
- Do not set the left/right rotation switch (11) during operation.
- The rotation direction is always according to the switch position.
- Switch position R: right-rotation/forward/clockwise. To drill and to screw in screws, push the right/left
rotation switch (11) to the left until the stop.
- Switch position L: left-rotation/backwad/counter-clockwise. To loosen or pull out screws and nuts, push
the right/left rotation switch (11) to the right until the stop.
Switching on/off
- First insert a designated drill/screw bit into the power tool (see Before operation).
- Connect the power plug to a designated outlet.
- Attach the impact drill directly to the drill spot.
- Press and hold the on/off switch (9) to switch the machine on.
- To switch the machine off, release the on/off switch (9).
Long duration operation
Danger of accident!
If the machine should fall out of your hand during long duration operation, it will not
automatically shut off.
DANGER!
In this situation, pull out the power plug immediately and turn the machine off. To ensure a safe long
duration operation:
Designated
drill
Hard metal drill
Wood, metal,
plastic plastic
Steel HSS drill
Rotation
speed
High
Low
Low
as soon as the drill has penetrated the tile.
(drilling).
GB
17