Braun Silk&Soft LS 5100 Manual De Instrucciones página 9

Trimming & Styling
For precise lines and contours like the
bikini line, lock the long hair trimmer
sliding the TrimLock
«trim» (C1).
To trim hair to a uniform length (about
4 mm), e.g. in the bikini area, lock the long
hair trimmer and place the OptiTrim
3d
attachment onto the shaver head (C2).
2
When you are finished
After shaving, you may want to smooth on
a little body cream or lotion. However,
avoid using irritating substances like
deodorants with alcohol right away.
Cleaning
This appliance is suitable for
cleaning under an open water
tap.
Regular cleaning ensures better shaving
performance. After each shave, proceed
as follows (D1):
• Press the release buttons
the shaver head.
• Rinse the shaver head and the cutter
block separately under warm running
water. A natural based soap may
also be used provided it contains no
particles or abrasive substances. Rinse
off all foam.
• Leave the cutter block and shaver head
to dry separately.
Alternatively, you may clean the shaver
using the brush provided (D2):
• Press the release buttons
the shaver head. Tap the bottom of the
shaver head gently on a flat surface (not
on the foil).
• Brush out the cutter block and the
inside of the shaver head. However, do
not clean the shaver foil with the brush
as this may damage the foil.
10
3d
to the position
5
to remove
4
to remove
4
Keeping your Braun Silk&Soft
in top shape
by
• The shaving parts need to be lubricated
regularly every 3 months (E). If you
clean the shaver head under running
water, lubricate it after each cleaning.
Apply some light machine oil or vase-
line to the shaver foil and the metal
parts of the long hair trimmer. Then
remove the shaver head and also apply
a tiny amount of vaseline as shown in
picture section (E).
• The shaver foil and the cutter block
are precision parts that wear out with
time. To maintain optimum shaving
performance, replace your foil and
cutter block when you notice a reduced
shaving performance.
• Do not shave with a damaged foil.
• How to replace the shaving parts
Shaver foil: Press the release buttons
to remove the shaver head. To
4
remove the shaver foil, press the blue
plastic frame (F). To mount a new one,
insert it from inside the shaver head.
Cutter block: To remove the cutter
block, press and turn it 90° (G1), then
take it off. To put on a new cutter block,
press it onto the cutter block holder and
turn 90° (G2).
Subject to change without notice.
This product conforms to the
EMC-Directive 89/336/EEC.
Please do not dispose of the
product in the household waste at
the end of its useful life. Disposal
can take place at a Braun Service
Centre or at appropriate collection
points provided in your country.