Change Language; Change Administrator Password; Delete All Program Passwords; Factory Settings - BriskHeat ACR 3 Manual Del Usuario

Change Language:

This function changes the displayed language. The ACR
(Deutsch).
NOTE: This function requires a shut down and reboot.
1. Access the SYSTEM menu.
2. Touch LANGUAGE, SPRACHE button.
3. Select either English, Deutsch, or Cancel.
4. Press OK to shut down hot bonder.
5. Flip the red main power switch to the OFF position. The main power switch is not illuminated
when off.
6. Flip the red main power switch to the ON position. The main power switch is illuminated when
on.
7. Software now displays desired language.

Change Administrator Password:

This function permanently changes the administrator password: Requires administrator
password.
1. Touch the SYSTEM tab at the top of the screen.
2. Touch the PASSWORD ADMINISTRATION button.
3. Touch the ENTER ADMINISTRATOR PASSWORD field. A keyboard screen appears.
4. Type your administrator password. Touch the ENTER button when complete.
NOTE: Factory default password is "3-RCA".
5. Touch the ENTER NEW PASSWORD field. A keyboard screen appears.
6. Type your new administrator password. Touch the ENTER button when done.
7. Touch the RE-ENTER NEW PASSWORD field. A keyboard screen appears.
8. Re-type your new administrator password. Touch the ENTER button when done.
9. Touch the UPDATE ADMIN PASSWORD button.
NOTE: System is in administrator mode until the hot bonder is shut down. See Shut Down
System on page 24 to shut down system.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
®
3 displays either English or German
25

Delete All Program Passwords:

This function deletes all program passwords stored in the ACR
password.
1. Touch the SYSTEM tab at the top of the screen.
2. Touch the PASSWORD ADMINISTRATION button.
3. Touch the ENTER ADMINISTRATOR PASSWORD field. A keyboard screen appears.
4. Type your administrator password. Touch the ENTER button when complete.
NOTE: Factory default password is "BHT".
5. Touch the DELETE ALL PROGRAM PASSWORDS button.
6. Touch OK button to confirm.
NOTE: System is in administrator mode until the hot bonder is shut down. See Shut Down
System on page 24 to shut down system.

Factory Settings:

®
This function is for BriskHeat factory only. It sets up the initial parameters.
CLEANING AND DECONTAMINATION
Clean only with a damp cloth and mild detergent, exterior only. No water should penetrate the
enclosure.
EQUIPMENT MAINTENANCE
Return to factory for repair, annual calibration, or maintenance. Contact factory at 1-800-848-7673
(toll free, U.S. / Canada) or 614-294-3376 for complete details.
®
© BriskHeat Corporation. All rights reserved.
®
ACR 3 Hot Bonder
®
3. Requires administrator
26