Kenmore 405.54530 Manual De Uso página 11

REMOVING THE COLLECTED WATER
There are two ways to remove collected water.
1. Use the bucket
* (f the bucket is full or if the bucket is removed when the unit is turned off, the unit
will beep 4 times, the Full indicator light will turn on, and the display will show P2.
* When the bucket becomes full when the unit is turned on, the compressor turns off,
the fan runs for another 30 seconds to dry water off of the evaporator coil, the unit
will beep 4 times, the Full indicator light will turn on, and the display will show P2.
* Slowly pull out the bucket. Grip the left and right handles securely, and carefully
pull out straight so water does not spill. Refer to Figures 5 & 6. Do not put the
bucket on the floor because the bottom of the bucket is uneven, causing it to fall
over and spill the water.
® Empty the bucket and replace it. The bucket must be in place and securely seated
for the dehumidifier to operate.
* The machine will re-start when the bucket
is restored in its correct position, assuming
that the 3 minutes safety delay for the
compressor has passed.
NOTES:
• When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product.
• Be sure to push the bucket gently all the
way into the unit. Banging the bucket against
anything or failing to push it in securely may
cause the unit not to operate.
• When you remove the bucket, if there is some
water in the main unit you must dry it up before
continuing.
2. Continuous draining
* Water can be continuously drained into a floor
drain by attaching a length of garden hose (ID _>
5/16"with a female threaded end ID 1", not
included) onto the unit.
*Affach the drain tube securely to adaptor
A (see Fig. 7).
Pull out the bucket a little.
Figure 5
Hold both sides of the bucket
with even strength, and pull it
out from the unit.
Figure 6
Pour the water out.
Drain tube
Adaptor A
Figure 7
11