D-Mail DoctorVideo DV 01 Manual Del Usuario página 19

Connecting OUTPUT devices with Doctor Video
Doctor Video may be connected to a large selection of analog or digital devices provided with RCA output terminals (VHS players, VHS camcorders, VHS-C
camcorders, Mini DV camcorders, DVD camcorders, DVD players, etc.). Follow these instructions to connect the devices containing the files to be converted:
Connecting OUTPUT devices through RCA cable (fig. 8)
Be sure that Doctor Video and the device to be connected are switched off or in stand-by mode . Identify the RCA OUTPUT terminals of the device
to be connected and proceed as follows . Each end of the RCA cable has three jacks . Connect the cable as shown in Figure 8:
• Insert the RED jack into the plug on Doctor Video's rear panel identified as "AUDIO IN (R)" .
• Insert the WHITE jack into the plug on Doctor Video's rear panel identified as "AUDIO IN (L)" .
• Insert the YELLOW jack into the plug on Doctor Video's rear panel identified as "VIDEO IN" .
• Insert the other end of the cable into the plugs of the device to be connected
Connecting OUTPUT devices through RCA-3.5mm jack cable (fig. 9)
Be sure that Doctor Video and the device to be connected are switched off or in stand-by mode . Identify the RCA OUTPUT terminals of the device
to be connected and proceed as follows .
• Connect the RCA cable with the plugs on the device to be connected .
• Insert the 3 .5mm jack into the provided plug located on Doctor Video's front panel identified as "A/V INPUT" .
The RCA-3 .5mm jack cable is not included . Please buy it separately .
3.2 CONVERTING yOUR VIDEOS
PLAY
2
Press
When the analog sources and the memory devices specified in Section 3.1 are properly connected with Doctor Video, video conversion can be performed
as follows.
• Turn on Doctor Video as specified in Section 2 .1 . Connect and select the memory device where you want to save the converted video as speci-
fied in Section 2 .5 .
• Turn on the output device and start playing the video to be converted . Be sure that the RCA output has been used .
• Press "REC" on Doctor Video's front panel or on the remote control .
• Select the proper input terminal (RCA or A/V INPUT) using
• Press "REC" again to confirm your selection . Doctor Video will start converting the file . You may follow the procedure on the TFT display .
• Press "STOP" to pause the conversion . The TFT display will show the message "Wait for the end of the conversion" for a few seconds; then the
display will show the files stored in the memory device used for the conversion .
• Now you can stop playing the video from the output device
• The converted video will be stored in the selected memory device .
Warning: 1GB memory can encode around 1 hour video .
Warning: As some USB/SD card can refuse long period of conversion, so we suggest to encode for no more than 2 hours .
Inserting voice memos into your videos.
Doctor Video allows you to insert voice memos into your videos during digital conversion . Just plug a microphone into the provided connector
identified as "MIC" on the rear panel . To insert voice memos while converting videos, refer to the images in the TFT display and speak clearly into
the microphone . Your voice will be overdubbed on the video soundtrack .
ENCODING ON USB MEMORY
Conversion
00:04:09
time
Figure 10 – Display information while converting
PLAY on the videorecorder
and
Encoding on memory
device
CONVERT
3
Press
keys .
Figure 11 – INPUT Selection
18
REC on DOCTOR VIDEO
Select RCA input
RCA input
Select
A/V input
A/V input