Broan Best EB15 Manual Del Usuario página 4

INSTALL THE BLOWER
ROOF INSTALLATIONS
1. Remove the cover and screws.
2. Attach an appropriate U.L. approved
cable connector in the hole at the rear
of the wiring box.
3. Remove roofing nails from shingles
around the TOP and SIDES of the cut-
out area only.Carefully lift the shingles
to allow the back flashing sheet on the
blower housing to fit under them.
4. Center the blower ring in the 11" diameter
hole, making sure that the 1¼" diameter
electrical wiring hole aligns with the hole
in the wiring box.
5. Attach the blower to the roof with six (6)
screws provided. It is recommended that
the screws be located inside the blower
housing. Drill pilot holes if necessary.
6. Using a good grade of roofing cement,
seal all of the shingles around the hous-
ing and flashing sheet as well as the
mounting screw heads.
7. Bring electrical wiring through the hole
in the wiring box and secure it according
to local codes.
GROUND
TO
GROUNDING
SCREW
WHITE
WHITE
TO
TO
BROWN
BLUE
8. Make the electrical connections with the
proper connector for the type of wiring
being used. Connect black to black, white
to blue, and the green or bare wire to
grounding screw.
9. Replace cover and screws. Do not pinch
wiring under the cover.
10. Make sure damper opens and closes
freely.
120 VAC
LINE
BLACK
BLACK
TO
TO
BLUE
BLACK
INSTALL THE BLOWER
WALL INSTALLATIONS
1. Place a large bead of caulk on the back
side of the housing all along the outer
edges.
2. Center the blower ring in the 11" diameter
hole, making sure that the 1¼" diameter
electrical wiring hole aligns with the hole
in the wiring box.
3. Attach blower to the wall with the six (6)
screws provided. It is recommended that
the screws be located inside the blower
housing. Drill pilot holes if necessary.
4. Using a good grade of caulk, seal all
around the mounting screw heads.
5. Bring electrical wiring through the hole
in the wiring box and secure it according
to local codes.
GROUND
TO
GROUNDING
SCREW
WHITE
WHITE
BROWN
6. Make the electrical connections with
IN
the proper connector for the type of
wire being used. Connect black to black,
white to blue and green or bare wire to
grounding screw.
7. Replace cover and screws. Do not pinch
wiring under cover.
8. Make sure damper opens and closes
freely.
9. Top and side flanges of the back plate
may be covered with trim strips. Do not
block grille opening at bottom with trim.
It will adversely affect performance of the
blower.
4
TO
TO
BLUE
BLACK
BLACK
TO
TO
BLUE
BLACK
120 VAC
LINE
IN