Figure 1 Brackets Attached To Ehorn - Federal Signal eHorn Instrucciones De Instalación Y Servicio

Mounting the eHorn with the Brackets
For dimensions, see Figures 2 and 3 on page 10.
NOTE: For trunnion (U‑bracket) mounting, the Model
EHORN‑TKIT is available as an accessory. Refer to instruction
manual 25500314 for bracket kit details.
To secure the eHorn to the mounting surface:
1. See Figure 1. Attach the mounting brackets to the eHorn
with the six supplied 1/4 in‑20 x 5/8 in screws. Tighten
them to 80 +/‑10 in‑lb.

Figure 1 Brackets attached to eHorn

1/4"-20 x 5/8" (6)
2. Hold the eHorn against the mounting surface and use the
two mounting holes on the bracket as a template. Scribe
drill‑position marks on the mounting surface.
3. Remove the eHorn and drill a hole at each mark.
4. Secure the eHorn to the mounting surface using installer‑
supplied 1/4 in screws.
Installation and Maintenance Instructions
Model eHorn
290A7910
9