Connection Example; Technical Data - Urmet alpha 1168/45 Manual De Instalación

ENGLISH
DESCRIPTION
The device Ref. 1168/45 is the proximity key reader
for modular door unit Mod.1168.
It has two operating modes:
• Standalone mode: the device activates the
relay if a valid key is detected.
• Implemented in 2Voice / Ipercom systems;
it must always be paired with the following
devices in this case:
– Audio door unit module (Ref. 1083/38)or
audio video door unit module (Ref. 1083/48);
– Display module (Ref. 1168/1;
– Numeric keypad module (Ref. 1168/46.
Only one module Ref. 1168/45 can be installed
for each calling station.
For information how to use the device
implemented in 2Voice systems, download
the booklet using the QR Code at the end of
this booklet.

CONNECTION EXAMPLE

Rear view of the modules fixed to the panel
frame in tipped position.
DS1168-008A
6 cm long cord provided with modules Ref.
A
1168/xx.
CAPABILITIES
Permits timed opening (from 0 to 99 seconds)
when:
— a user proximity key is placed close to the front
panel;
— the door-release key in the entrance to the
building is pressed (in standalone mode only).
Each time the door is opened, the 3-digit display,
if enabled, shows the type of activation and the
number of the key that has caused this, according
to the following conventions:
'nnn' number of the user key;
internal entrance button;
key not recognized.
Il led bicolore,
riconoscimento di una chiave di prossimità
avvicinata al frontale cambiando colore (da rosso
a verde).

TECHNICAL DATA

Power supply: .....................................12 V
Power requirement: .................................... 310 mA
Operating temperature: ...................... -10 ÷ +50°C
Door open contact:
Type of contact:................................. C, NC, NO
Max. switchable voltage: .............................30 V
Max. switchable current: ........................... 3,5 A
Max. load: .................................... 40 VA / 25 W
Timing: ...................................................0 ÷ 99 s
Supported user key type:
Mifare (Ref. 1125/52) or Mifare Plus
Max. number of keys that
can be stored .................................................. 2000
(1997 user keys and 3 master keys)
Wires with cross-section area of 0.5 mm
larger must comply with IEC 60332-1-2; wires
with crosssection area smaller than 0.5 mm
must comply with IEC 60332-2-2.
se abilitato, visualizza
~
or 10.5 – 15 V
il
±20%
or
2
2
9