Vollrath FC-4HS-24120-SSR Manual Del Operador página 3

CLEANING
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Hot surfaces and food can burn skin. Allow the hot surfaces to
cool before handling.
TROUBLESHOOTING
Problem
Shelf temperatures is too high, too
low or is heating unevenly.
Shelf does not heat, but control panel
is illuminated.
Shelf suddenly turns off.
Control panel does not illuminate.
Control panel is beeping.
Heated Shelf Drop-in Operator's Manual
Might be Caused By
Problem with an internal component.
Problem with the heating element.
Problem with the thermistor.
Electrical failure
Heating element failure
Problem with an internal component.
Power cord is disconnected
USB control cable is disconnected
Control panel is not communicating with
shelf because USB cable is disconnected or
damaged
Issue with the electrical power to the drop-in
Problem with internal components
Damage to control panel
A problem with a sensor or heating element. Contact Vollrath Technical Services.
To maintain the appearance and increase the service life, clean your
equipment daily.
NOTICE: Do not use caustic cleaning chemicals, steel wool or
commercial lime removal products to clean the equipment.
Thoroughly rinse equipment with water after cleaning.
1. Press the heat zone button(s) to turn off the equipment.
2. Unplug the equipment.
3. Use gloves, mitts or pot holders to protect hands when removing
containers of hot food.
4. Allow the equipment to cool completely before cleaning.
5. Use a damp cloth or sponge dipped in soapy water to clean the
equipment.
6. Use a damp cloth or sponge dipped in clean water to rinse the
equipment.
7. Use a soft cloth to thoroughly dry the equipment.
F
Course of Action
Contact Vollrath Technical Services.
Contact Vollrath Technical Services.
Contact Vollrath Technical Services.
Plug in the power cord
Check the USB cable connections to the control panel and the
power box mounted to the bottom of the shelf.
Check the USB cable connections to the control panel and the
power box mounted to the bottom of the shelf.
Verify the equipment is plugged into an electrical outlet with
the correct voltage, and on its own separate circuit
Contact Vollrath Technical Services.
3