Buggypod lite Manual De Montaje página 6

9. ATTACHING 10. CHECKING
LEASH INSTALLATION
Attach the longer section of the Optimal assembly is attained with
leash (o) to the upper tubing on the Buggypod® standing level to
the right-hand side of the pushchair.
floor (Step 14) and the wheel in line
Loop the leash around the tubing with the pushchair wheels (Step 13).
and thread through the buckle at least
2 x. Make sure it is anchored at a point
where it can not slip down. Attach the
shorter leash section to the upper
left side of the Buggypod® chassis,
and below the raincover/sunshade
anchor points if using those accessories.
Connect the two ends. The leash should
be taut but not pull the Buggypod® off
the ground. The leash provides upper
stability and should be connected to
the Buggypod® every time it is used
as a side-seat attached to the host
pushchair. Cut off excess leash once
fitted to avoid any entanglement
hazard. Open leash before folding
Buggypod®.
12. FOLDING UP THE BUGGYPOD®
AGAINST THE PUSHCHAIR
a. Press down left rear lock until it b. Press green button above right rear
stays down lock and then press and hold down
right rear lock.
11. BUCKLING IN
YOUR CHILD
Ensure the brakes are applied to your
pushchair before seating your child
in the Buggypod® with the 5-point
harness. Connect the two waist buckles
with the crotch harness buckle, and
connect the shoulder straps to the waist
buckles. Adjust the length of the waist
and shoulder straps for a secure but
comfortable fit. Squeeze the tabs to
release the buckles. D-ring anchors
are located in the corners of the seat
should you wish to use an additional
safety harness (not included).
c. Push backrest forward until d. On the hinge (p), push the green
Buggypod® is fully folded into itself lever down.
6
e. Press green button while holding f. Press the other green button of hinge
lever in position. while holding first green button.
i. insert into wheel storage hole j. Fold up footrest if required.
underneath hinge.
g. Fold Buggypod ® against side of h. Remove wheel from axle by
pushchair pressing button in centre
7