Setup; Battery Installation; Battery Precautions; Battery Saver - Jasco 34932 Instruction Manual

Setup

Your universal remote requires two (2) AAA batteries
(not included). Alkaline batteries are recommended.

Battery Installation

1. On the back of the remote, slide the cover down
to remove.
2. Match the (+) and (-) marks on the batteries
to the (+) and (-) marks inside the battery
compartment, then insert two (2) AAA batteries.
Be sure to use fresh batteries.
3. Slide the battery cover back into place.
NOTE: If your remote stops operating properly,
replace the batteries with new ones.

Battery Precautions

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with local and national regulations.

Battery Saver

Your remote automatically turns off if the buttons
are depressed more than 8 seconds. This will save
your batteries should your remote get stuck in a
place where the buttons remain depressed (e.g.,
between the sofa cushions).

Code Saver

You have up to 10 minutes to change the batteries
in your remote without losing the codes you
have programmed.
3