Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Guide Light.
Your ET200™ comes equipped with a guide light at the front of the tool figure 1. The light will be activated upon pressing the trigger. Your ET200™ has a safety switch at the nail exit point figure 2 that will prevent your tool from
firing when not in contact with a work surface. To properly use your LED guide light, press trigger before tool makes contact with your work surface. After making contact with the work surface, release trigger, then press trigger
again to fire a nail.
You will find this helpful when firing nails into tighter corners and poorly lit areas.
f f i i g g u u r r e e 1 1
f f i i g g u u r r e e 2 2

MAINTENANCE

Your ET200™ is virtually maintenance free. Keep tool clean and free of dust. Wipe clean with a dry cloth do not use harsh chemicals to clean your ET200™.
Your ET200™ contains no user serviceable parts. In the unlikely event that your ET200™ should need service contact:
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, N.J. 07663
Tel. 201 843-6900
On very hard surfaces firing recoil may
interfere with nail penetration. Enhance
driving power by firmly placing one hand
on top of cap.
ET200220™ (220-240v)
ET200™ (120v)
Use Only An Earth Cable
Use #12
Extension Cord
extension cord.
BACK TO
INDEX
6

Publicidad

Tabla de contenido
loading

Tabla de contenido