Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Apollo 3
Fixed Cycle Timer
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Mount Apollo 3 near equipment to be operated,
away from water, mist, etc.
2. Plug equipment to be controlled into the Apollo 3.
3. Do not exceed 10 amps.
4. Plug the Apollo 3 into a 120 volt outlet.
5. Equipment will cycle one (1) minute "On"
and four (4) minutes "Off" until power is defeated.
6. To reset Apollo 3, unplug timer & then plug
back into outlet. Timer will always start with the
"On" cycle.
Controller Specifi cations
Size: 4"
2"
2.5"
H x
W x
D
Weight: 1 lb.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 10 amps
Hertz: 60 Hz
On Time: 1 minute
Off Time: 4 minutes
o
o
Operating Temperature: 35
to 125
F | 2
o
o
Storage Temperature: 32
to 135
F | 0
Cord Set: Wall mount
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Aeroponics System
Apollo 3
Ebb & Flow System
Apollo 3
o
o
to 53
C
o
o
to 57
C
Controlling a Drip Feed
Apollo 3
Controlling an
Controlling an
Publicidad
Manuales relacionados para Titan Controls Apollo 3
Resumen de contenidos para Titan Controls Apollo 3
- Página 1 Aeroponics System Instructions for Use 1. Mount Apollo 3 near equipment to be operated, away from water, mist, etc. 2. Plug equipment to be controlled into the Apollo 3. Apollo 3 Apollo 3 3. Do not exceed 10 amps. 4. Plug the Apollo 3 into a 120 volt outlet.
- Página 2 Instrucciones de uso 1. Instale el Apollo 3 cerca del equipo que se pondrá Control de un en funcionamiento, lejos de atomizadores, agua, sistema aeropónico etc. 2. Enchufe el equipo que se controlará en el Apollo 3. No exceda los 10 amperios.