Hoover DYM 896T WIFI Instrucciones Para El Uso página 24

DISHWASHER
ENROLMENT
Terminology and tools
- Wi-Fi SYSTEM:
You can activate the remote control
system of the dishwasher via Wi-Fi, this
will allow you to control various aspects
of the dishwasher's operation. For
example, selecting and starting a wash
cycle or stopping a wash cycle that's in
progress. If the remote control system is
disabled, then the app will still allow you
to track the progress of a wash cycle and
see how much time is left until it completes.
However you cannot control any of the
dishwasher functions through Wi-Fi.
- REGISTRATION PROCEDURE:
This is the process by which the dishwasher
is connected to a wireless router and
enables communication with the app.
- ON/OFF BUTTON:
If the dishwasher is switched off (via the
"ON/OFF" button or disconnected from
the mains supply, then functionality
through the remote control system will
not be available. To reactivate the Wi-Fi
system, restore
dishwasher, select the P0 programme
and then press the "START/RESET"
button.
- RESET:
To restore the Wi-Fi system to factory
settings, you need to press two buttons
simultaneously
message AP. On freestanding models,
you should press the "SUPER ECO"
and "ALL IN 1" buttons.
On built-in models, you should press the
"ACTION PRO" "
power to the
until display the
" and " " buttons.
- MODEM SETTING:
To activate the Wi-Fi capabilities of your
dishwasher, you will need to link it to
your internet router or hub. To establish
a wireless connection, you will need to
input the router/hub ID and password.
The dishwasher will only be compatible
with a modem that has the specifications
shown in the table below. If it doesn't,
then you may not get a Wi-Fi signal.
Wi-Fi uncertified routers may fail to
establish the connection.
Parameter
Frequency
Modulation
Channel
intervals
Channels
Transmission
rate
(over the air)
Receive
sensitivity
Output level
(Class1)
24
Specifications
2,402 ~ 2,480 MHz
802.11b compatibility:
DSSS (CCK-11, CCK-5.5,
DQPSK-2 and DBPSK-1)
802.11g:
OFDM (default)
5 MHz
1-14
1-11 Mbps for 802.11b
6-54 Mbps for 802.11g
-83 dBm typical
0 to +12 dBm (software
configurable)