Configure Your Computer's Tcp/Ip Settings - Signamax Connectivity Systems 065-1755 Manual De Instrucciones

Ethernet port: The Ethernet LED lights up when Ethernet port of AP was
connected to LAN. When the LED is flashing that indicates the network
activity over that port.

3. Configure your computer's TCP/IP Settings

Windows 2000/XP
1. Click Start; click Settings and then click on the Control Panel.
2. Double-Click the Network Connection icon.
3. Right-Click on the Local Area Connection icon and then click on
Properties. The Local Area Connection Properties windows will appear.
4. Under the General Configuration Tab, locate and select TCP/IP with
the corresponding network card, then click Properties. The Internet
Protocol (TCP/IP) Properties window will appear.
5. Click on Use the following IP Address and enter
IP Address: 192.168.1.10
Subnet Mask: 255.255.255.0
Default gateway: 192.168.1.1
5