Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Powering a Telescope
Pull the rubber cover from the charging/power port on
the side of the PowerTank Lithium Pro and plug in the
telescope power cord. One side of the cable has a
threaded connector for attaching to your telescope.
The smooth end fits into the battery. Press the power
button on the control panel twice to activate power. The
battery indicator lights will blink in sequence to show that
power is flowing.
Car Battery Port
The PowerTank Lithium Pro comes with a car battery
adapter port that provides 12V DC power (10 amps) to
power other external accessories. Flip up the cap covering
the port and insert your car battery adapter into the port.
Press the power button on the control panel once to
activate power. The battery indicator lights will light up
to show that power is flowing.
Illumination
The LED light panel can be used with red or white light.
Red light will allow you to see in the dark while protecting
your night vision. White light can be used when protecting
your night vision is not important.
To activate the red LEDs, press the lighting control button
once. To increase the brightness, press the button a
second time. To turn it off, press it a third time.
To activate the white LEDs, press and hold the lighting
control button for two seconds. To increase the brightness,
press the button again. To turn it off, press and hold the
button for two seconds.
ATTACHING THE POWERTANK LITHIUM PRO TO YOUR
TELESCOPE
The PowerTank Lithium Pro can be set on a telescope
accessory tray in either horizontal or vertical orientation.
It can also be attached to a tripod leg by using the 2.5
inch wide hook and loop strap. Slip the strap through the
two slots in the tripod leg mount. Start by wrapping the
strap around the tripod leg, then feeding the end of the
strap through the buckle. Pull the strap back and secure
the hook and loop strap to the desired tension.
I
ENGLISH
5
Publicidad
Capítulos
Tabla de contenido
