Focus Assistant - Axis P1355-E Guia De Instalacion

AXIS P1355-E/P1357-E Installation Guide
• The iris should always be opened to its maximum while focusing, which gives the smallest depth of
field and thus the best conditions for correct focusing.
Zoom puller
Focus puller

Focus Assistant

To focus using the Focus Assistant, follow the instructions in steps 1 - 3 on page 12 before you start
with the steps below.
1. Mount or place the camera so that it cannot be moved.
2. Loosen the zoom puller by turning it anti-clockwise. Move the puller to set the zoom level.
Retighten the zoom puller.
3. Set the camera to its extreme distant-focus position by loosening the focus puller and turning
the focus ring fully clockwise.
4. Press and quickly release the Control button. When the Status LED flashes green, the Focus
Assistant is enabled.
If the Status LED flashes either red or amber before you are able to adjust the lens, skip to step
7 to exit the Focus Assistant and repeat steps 3 - 7. See the notes below.
5. Gently turn the focus ring anti-clockwise until it stops.
6. Finally, turn the focus ring slowly clockwise until the status indicator flashes green or amber
(not red).
7. To exit the Focus Assistant, press the Control button again.
Note: The Focus Assistant is switched off automatically after 15 minutes.
8. Retighten the focus puller.
9. Open the Live View page in the web browser and check the quality of the image.
10. Continue with steps 6 - 8 on page 12.
Control button
Page 13