Resetting To The Factory Default Settings; Further Information - Axis P1355-E Guia De Instalacion

Ocultar thumbs Ver también para P1355-E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

AXIS P1355-E/P1357-E Installation Guide

Resetting to the Factory Default settings

This will reset all parameters, including the IP address and focus position, to the Factory Default
settings:
1. Disconnect power from the camera.
2. Press and hold the control button and reconnect power.
3. Keep the control button pressed until the status indicator displays amber (this may take up to
30 seconds).
4. Release the control button. When the status indicator displays green (which can take up to 1
minute) the process is complete and the network camera has been reset.
5. Re-assign the IP address, using one of the methods described in the documentation available
on the CD.
6. Refocus the camera, using one of the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the User Manual.

Further Information

The User Manual is available from the Axis Web site at www.axis.com
Visit www.axis.com/techsup to check if there is updated firmware available for your network
product. To see the currently installed firmware version, see Setup > About.
Visit Axis learning center www.axis.com/academy for useful trainings, webinars, tutorials and
guides.
Warranty
For information about Axis' product warranty and thereto related information, see
www.axis.com/warranty
Page 19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P1357-e

Tabla de contenido