HAMPTON BAY Windward IV Manual Del Propietário página 13

on your control. To select your desired
room temperature, press the button to dis-
play FAN AUTO on the LCD display.
Use the TEMP./SET/HOUR BUTTONS
to set the desired temperature from
59˚F~99˚F The fan will start automatically
on low speed when the room temperature
is equal and up to 4˚ F over the set tem-
perature. The speeds will change from low.
Medium and high as the temperature in-
creases or decreases in 4˚ F increments.
Example:
Set temperature 72˚ F Room temperature 71˚ F off
Set temperature 72˚ F Room temperature 72˚ F Low
Set temperature 72˚ F Room temperature 76˚ F Med
Set temperature 72˚ F Room temperature 80˚ F High
Note: To select Fahrenheit or Celsius temperature:
Press the TEMP./SET/HOUR buttons
same time until the F or C symbol appears beside
the Temp number.
e. Light Button (orange): This button turns
the light on or off and also controls the
brightness settings as
and release the button and the light will
turn on or off. Press and hold the but-
ton to set the desired light brightness.
The light brightness is display on the LCD
display in percentage number ranging from
100% to 20%. The light will cycle continu-
ously between bright and dim setting as
the button is held down. The light button
features auto resume, this feature allows
the light brightness to remain at the same
brightness setting as the last time it was
turned off.
f. LIGHT TIMER and FAN TIMER buttons:
Use this button to set the sleep timer from
0.5 to 24 hr, in one hour increments. Press
the LIGHT or FAN TIMER button once,
the timer symbols will be displayed on the
LCD display. Note: you have 6 seconds to
set the sleep time, if you do not perform
any entries during this time, the light timer
display will be turned off automatically.
To re-set it, simply press the button again.
Use the TEMP./SET/HOUR buttons
set the desired sleep time starting from
0.5,1,2,3,....24 hr, The light or fan both will
be turned off automatically when the pre
set Time expires. If the fan is in the FAN
at the
AUTO mode, it will return to MANUAL
mode when the sleep timer expires.
g. LIGHT- Delay- Pressing this button acti-
vates the light delay function. The light will
follows; Press h. automatically shut off after 3 minutes.
Setting the Code
This unit has 16 different code combinations.
To set the code, perform the following steps:
A. Setting the code on the transmitter:
a. Remove the battery cover. Press firmly
below arrow and slide battery cover off.
b. Slide code switches to your choice of up
or down position. (Factory setting is all up).
B. Setting the code on the receiver.
a. Slide code switches to the same position
as set on your transmitter.
b. Replace battery cover on the transmitter.
to
11.