Installing The Light Kit - HAMPTON BAY Windward IV Manual Del Propietário

ment. Repeat for each blade. Measurement
deviations should within 1/8". Run the fan
for 10 minutes.
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.

Installing the Light Kit

CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Remove one screw from the black bracket be-
low the fan motor assembly. Loosen, but do
not remove the other two screws (Figure 16).
2. Connect the blue wire exiting the bottom of
the fan motor assembly with the black wire
from the top of the light kit fitter assembly.
Connect the white wire exiting the bottom
of the fan motor assembly with the white
wire from the top of the light kit fitter as-
sembly (Figure 16).
3. Attach the light kit assembly to the fan motor
assembly by securing with the two screws
loosened in step 1. Push light kit assembly
up to engage screw heads in slots and turn to
secure. Tighten each screw firmly.
4. With the power off, install the two fluores-
cent bulbs (Max. 13W, provided) into the
light bulb sockets.
5. Place the glass shade into the light kit as-
sembly, aligning the three flat areas on the
top flange of the glass shade with the three
Figure 15
raised dimples in the light kit assembly.
Turn the glass shade clockwise until it stops
(Figure 17).
DO NOT OVERTIGHTEN WHEN INSTALLING THE
GLASS SHADE INTO THE LIGHT KIT ASSEMBLY.
ALLOW THE GLASS SHADE TO COOL COM-
PLETELY BEFORE REMOVING.
OVER LAMPING THE FAN WILL RESULT IN
THE FAN LIGHTS SHUTTING DOWN UNTIL
THE PROPER WATTAGE OF BULBS ARE IN-
STALLED. RESET THE LIGHTS BY TURNING
OFF, REPLACE BULBS WITH THE CORRECT
WATTAGE BULBS, TURN ON.
Black Bracket
Blue
Black
Key Slot
Holes
Screws
Raised
Dimples
Flat Area
White
Light Kit
Assembly
Figure 16
Light Kit
Assembly
Bulbs(2)
(Provided)
Glass
Bowl
Figure 17
9.