Aukey BR-C16 Manual Del Usuario página 6

2. Once paired, disable the wireless function on Device A
3. Activate the wireless function on Device B and select "AUKEY BR-C16"
4. Once paired with Device B, reactivate the wireless function on Device
A and select "AUKEY BR-C16" in the list of paired devices
Notes
● NFC is a very short-range system. NFC devices should be touching or
extremely close to pair or connect. The position of the NFC chip in
devices also varies
● The BR-C16 will automatically enter standby mode after 1 minute in
pairing mode and automatically shut down after 10 minutes if no
devices are paired
● If your paired device is turned off or disconnected, the BR-C16 will
automatically enter pairing mode for 1 minute and then go into
standby mode
● The maximum wireless operating range is 10m (33ft). If you exceed this
range, the BR-C16 will disconnect from your paired device. The
connection will be re-established once you re-enter the wireless range
within 1 minute. The BR-C16 will automatically reconnect to the
last-paired device. To connect with other devices, repeat the previous
"Pairing" steps
Controls & LED Indicators
Functions
Answer or end a call
Reject an incoming call
Redial last-called number
Switch mic
Switch device
Play or pause
Cancel pairing
Instructions
Short-press the multi-function button
Press and hold the multi-function
button for 2 seconds
During a call, double-press the multi-function
button to switch between the BR-C16 and
your phone for talking
During a call, double-press the multi-function
button to switch between the BR-C16
and your phone for talking
When you have 2 phones connected and
get a call on one during a call on the other,
press and hold the multi-function
button for 2 seconds to switch between the
two phone calls
Short-press the multi-function button
Press and hold the multi-function button
for 2 seconds
- 04 -