Tool Specifications - Bostitch BTFP12569 Manual De Operación Y De Mantenimiento

OPERATION (CONTINUED)
Check operation of the contact arm mechanism frequently. Do not use the tool if the arm is
not working correctly as accidental driving of a fastener may result. Do not interfere with
the proper operation of the contact arm mechanism.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep angle as
this may cause deflection of fasteners which could cause injury.
Do not drive fasteners close to the edge of the work piece as the wood may split, allowing
the fastener to be deflected possibly causing injury.
This nailer produces SPARKS during operation. NEVER use the nailer near flammable
substances, gases or vapors including lacquer, paint, benzine, thinner, gasoline, adhesives,
mastics, glues or any other material that is -- or the vapors, fumes or byproducts of which are
-- flammable, combustible or explosive. Using the nailer in any such environment could cause
an EXPLOSION resulting in personal injury or death to user and bystanders.
When working on air tools note the warnings in this manual and use extra care when
evaluating problem tools.
BTFP12569 TOOL SPECIFICATIONS
All dimentions in inches unless otherwise specified
MODEL LENGTH
BTFP12569 20.35" (517 mm)
FASTENER SPECIFICATIONS:
MODEL
BTFP12569
BTFP12569
TOOL AIR FITTING:
This tool uses a 1/4" N.P .T. male plug. The inside diameter should be .200" (5mm) or larger. The
fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm²). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The BTFP12569 requires 3.7 cubic feet per minute (105 liters per minute) of free air to operate at the
rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm
be run to determine the amount of air required. For instance, if your fastener usage averages 30
fasteners per minute, you need 50% of the tool's c.f.m. of free air which is required to operate the
tool at 60 fasteners per minute.
BTFP12569_9R209353 MAN_Multi.indd 4
HEIGHT WIDTH
22.08" (561 mm) 3.15" (80 mm)
FASTENER CROWN WIDTH
BCS15xx 1/2" (13mm)
FLN-xxx -
MAINTAINING THE TOOL
WEIGHT
10.85 lbs (4.9 kg)
GAUGE FASTENER RANGE
15-1/2 Ga., 1/2" 1-1/2" (38mm) to
Crown Staples 2" (50mm)
16 Ga. "L" shape 1-1/2" (38mm) to
2" (50mm)
Cleat Nails
2
). Take the actual rate at which the tool will
-4-
1/27/15 9:29 AM