Saci smart Manual De Instalación Y Mantenimiento página 19

English
2 - DATE/TIME
In this submenu, the current date and time can be modified, which are very important
values because the filtration and lighting programs depend on the information provided
in this point.
The value to modify will flash, making modification more intuitive. The value to be
modified can be increased by pressing the button.
The changes made will not be effective until the OK button is pressed . This text is
shown when editing the minutes of the current time.
The time controller has an internal clock that together with the battery supplied guaran-
tee that the date and time set will not be lost if there is a power cut.
To replace the supplied CR2032 battery, disconnect the controller from the power su-
pply and wait at least 1 minute before replacing the battery with a new one.
3 - FILTRATION
In this submenu, the parameters and times referred to in the pump's filtration times
can be set.
On the first submenu selection screen, set the days the filtration is required to be active.
The filtration options available are Monday to Sunday (every day of the week) Monday
to Friday, only Saturday and Sunday or only Friday and Saturday.
Filtration can also be completely deactivated.
Press the button to modify the selection. Press to confirm.
If "FILTRATION OFF" is selected, configuration of the remaining parameters will not
continue.
If any of the other ranges of filtration days are selected, the process will continue to the
selection of daily filtration cycles. From 1 to 8 daily filtration cycles can be selected in
this screen, which can be modified with the button.
Once the daily filtration cycles have been selected, in the following screens start time
and the filtration time of each cycle individually, up to a maximum filtration time of
12 hours per cycle.
4 - LIGHTING
This is the submenu for editing the automatic activation of the swimming pool lights,
if this automation is required.
By default the lighting programme is deactivated, although it can be activated in a very
similar way to adjusting the filtration cycles in submenu "3. FILTRATION".
On the first screen, select the days on which to activate automatic lighting of the swim-
ming pool, selecting from the options of Monday to Sunday, Monday to Friday, Saturday
and Sunday and Friday and Saturday. Press to modify the selection. Press to save
the selection.
On the following screens set the start time for the lighting activation and the lighting
time required, up to a maximum of 12 hours.
5 - SKIMMING
The SKIMMING function (default disabled) aims to clean the surface of the water, for
those pools where the water becomes easily dirty while the pump is stopped when
falling on the water leaves, insects, etc ...
It allows the start and stop of the pump, automatically and for a fixed time of 3 minutes.
By pressing you can change how long the pump will start, from 1 hour to 5 hours
after the pump is stopped.
During the SKIMMING function, the led green RUN flashes.
19