Manual Functions - Saci smart Manual De Instalación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

All the other alerts/alarms are deactivated by default and are only operative for super-
vision by manually activating them.

11. MANUAL FUNCTIONS

The intelligent controller has, in addition to the programmable automated features for
activating the pump and the swimming pool lights, two manual functions that enable
manual start of the pump as well as manual activation of the swimming pool lights.
To manually activate the pump, from the stand-by screen select the pump timer acti-
vation submenu by pressing :
In this screen, each time
is pressed, the manual activation of the pump can be se-
lected for 2 minutes, 5 minutes, 30 minutes, 60 minutes, 2 hours, 4 hours, 8 hours or
deactivation. Just select the manual time desired and after a few seconds the pump will
be activated for the set time. The pump will deactivate once the intelligent controller
has checked that the selected time has transpired.
Note: It must be pointed out that if a filtration cycle begins during manual timing of
the pump, or the external intake enables the pump for operation, the pump will not
stop until the end of the manually selected time, as long as the programme filtration is
not finalised, or the external intake disables operation of the pump, respectively. It also
indicates that if the chlorinator outlet is enabled with operation of the pump, this outlet
will also be activated during manual operation.
To manually activate the swimming pool lights, there is a specific button
.
The same as for manual activation of the pump, each press enables manual operating
time of the lights to be selected:
In this case, the times that can be selected are 15 minutes, 30 minutes, 60 minutes,
2 hours, 4 hours, 8 hours, RGB or deactivation. Only the manual operating time must
be selected and after a few seconds the lights will activate for the manually set time.
Note 1: It must be pointed out that if a lighting cycle starts during the manual timing of
the lights, this will not stop until the end of the manually selected time, as long as the
automatic lighting time has not finalised.
Note 2: The RGB light mode allows us to change the color sequence of the focus, in
case of having RGB focus.
For each press of
, the color sequence of the focus will change.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido