Recommended Preventive Maintenance; Maintenance Of Carbon Brushes, Electrical Cord Care, Proper Storage - Triple S SSS Speedster 600H Manual Del Usuario

RECOMMENDED PREVENTIVE MAINTENANCE

CAUTION
WARNING
UPON RECEIPT
Check unit for any defects, missing or broken parts. Call Triple S with this information
along with any questions you may have.
DAILY/AFTER EACH USE
Check Intercept Micro Filter. Empty/remove if full. All Triple S vacuums must use genuine
Intercept Micro Filters to maintain valid vacuum warranty. Check Micro Cloth Filter. If dirty,
rinse out and air dry before replacing back into vacuum. All filters must be in place to
operate vacuum. This will keep up airflow and prevent the motor from laboring.
PERIODICALLY
Check harness for fit and comfort. Replace lost or damaged pieces. Replace motor carbon
brushes. Carbon brushes should be replaced with new ones. Old ones should be thrown
away.
1. Carbon brushes on the vacuum motor replaced after the first 800 hours of
operation by a Triple S authorized service or warranty center.
2. Carbon brushes replaced again after the next 400 hours of operation by a
Triple S authorized service or warranty center.
3. Carbon brushes replaced again after the next 200 hours of operation by a
Triple S authorized service or warranty center.
ELECTRICAL CORD CARE
NEVER stretch the cord tightly between the vacuum and the outlet. A cord that is stretched
or pulled will not function properly and creates a danger. After vacuuming, unplug the
extension cord at both ends and wind it up loosely.
• Wind the cord from the female receptacle to the male plug.
• If possible lay the cord out straight on the floor before winding.
• DO NOT wind the cord up by wrapping it around your hand and elbow.
Use only Triple S replacement extension cord, or one that is properly sized for your applica-
tion. Reference Important Safety Instructions item number 5. Extension cord jacket type
should be SJT or better.
PROPER STORAGE
When the vacuum is not in use, the vacuum and extension cord should be stored indoors
and in a dry place.
Owner's Manual
The following information is for use by qualified service
personnel only and provides guidance for troubleshoot-
ing and maintenance under normal working conditions.
UNPLUG the vacuum when working on the motor or
n
any electrical part.
CHECK the condition of all electrical cords before each use.
n
5