Tabla de contenido
Publicidad
GB
STARTING AND STOPPING - MP135N
The Sander is a compact design made for one handed
operation.
Grip the Sander firmly allowing the fore finger to operate the
On/ Off switch located at the front of the motor housing (Pic. 3).
To operate the Sander slide the switch to reveal the figure I.
To switch off slide the switch back to reveal the figure 0.
STARTING AND STOPPING - MP187N / MP280N
This machine is fitted with a "continuous running switch" (Pic.
3.1). To start the machine squeeze the ON / OFF trigger
(Pic. 3.2). When the machine starts press in the "continuous
running button (Pic. 3.1) located on the side of the handle,
release the ON / OFF trigger. The machine will now run
continuously without the need to maintain pressure on the
ON / OFF trigger. To stop the machine briefly squeeze then
release the ON / OFF trigger.
DUST EXTRACTION - MP135N / MP187N
This machine is supplied with a dust extraction facility. The
two dust extraction adapters will allow the Sander to be
connected to most vacuum cleaner hoses. We recommend
the use of this facility at all times, especially when sanding
medium density fibre board (M.D.F).
Always wear safety goggles and a dust mask. Always keep
the dust extraction holes in the vibrating plate free of dirt or
other obstructions.
DUST EXTRACTION – MP280N
This machine is fitted with a dust extraction outlet and
collection bag. We recommend that this facility is used at all
times, as well as using an approved face mask.
TECHNICAL SPECIFICATION
Voltage
Motor
No load speed
Pad dimensions
Sandpaper size
Sound Pressure Level
Sound Power Leve
Vibration Level
Weight
5 MAINTENANCE
Always keep your Sander clean, regularly clean out the
ventilation slots.
Do not use caustic cleaning agents to clean the plastic
housing.
Always keep the dust extraction holes in the vibrating plate
free of dirt or other obstructions.
Water must never come into contact with the machine.
The Palm Sander is designed for dry sanding only and
under no circumstances should it be used for wet sanding.
The Pad Sander is designed for dry sanding only and under
no circumstances should it be used for wet sanding.
NOTE
The Sander is not to be used for sanding Gypsum.
MP135N
MP187N
220-240 V ~ 50 Hz
220-240 V ~ 50 Hz
135 W
150 W
11.000 min
11.000 min
-1
100 x 110 mm
187 x 90 mm
100 x 155 mm
240 x 90 mm
LPA 87 dB(A)
LPA 66.5 dB(A)
LWA 98 dB(A)
LWA 77.5 dB(A)
2.66 m/s
6.45 m/s
2
1,3 kg
1,2 kg
14
WARNING!
MP280N
220-240 V ~ 50 Hz
300 W
12.000 min
-1
115 x 225 mm
115 x 280 mm
LPA 77,9 dB(A)
LWA 88,9 dB(A)
12.337 m/s
2
2,0 kg
-1
2
Publicidad
Tabla de contenido
