Turn It On - Motorola MOTOSLVR L7 Motomanual

3 When your phone indicates Charge Complete
and the battery indicator stops flashing,
remove the charger.
Tip: You can safely leave the charger
connected to the phone after charging is
complete. This will not damage the battery.
When you charge the battery, the battery level
indicator in the upper right corner of the
display shows how much of the charging
process is complete. At least one segment of
the battery level indicator must be visible to
ensure full phone functionality while charging.
To charge from your PC, connect a cable
from your phone's mini-USB port to a high-
power USB port on a computer (not a low-
power one such as the USB port on your
keyboard or bus-powered USB hub). Typically,
USB high-power ports are located directly on
your computer.
12 essentials
Both your phone and the computer must be
turned on, and your computer must have the
correct software drivers installed. Cables and
software drivers are available in Motorola
Original data kits, sold separately.

turn it on

1 Open your phone.
2 Press and hold the
power key for three
seconds.
The phone may
require several seconds to power on.
3 If necessary, enter your four-digit unlock
code (usually 1234 or the last four digits of
your phone number) and press OK to
unlock the phone.