Filter Installation - PUR P2QC8506BLS Manual Del Propietário

Installation Instructions (continued):
8. The Water Dispenser is equipped with a Manual Shut-Off Valve installed on the rear of
the unit (Figure 6) for easy access in case of an emergency. Remove sanitation plug
from the Shut-Off valve before installing the water line (Figure 7).
9. Connect the incoming water line into the open side of the Manual Shut-Off Valve
(Figure 6). This valve utilizes Quick-Connect Fittings, for which no tools are required.
Simply insert the end of the Tubing firmly into the Manual Shut-Off Valve until it
comes to a complete stop (approx. 1/4") (Figure 8).
WARNING: DO NOT OPEN THE COLD WATER SUPPLY VALVE AT THIS STAGE.
(See Installation of Filter)
To disconnect the Tubing from the Manual Shut-Off Valve, you must first remove the Blue
"Horseshoe C-Clip" from the Quick-Connect Fitting (Figure 9). Then push in the Collet and
pull out the Tubing to remove it from the Manual Shut-Off Valve (Figure 7).
NOTE: The Blue"Horseshoe C-Clip" must always be installed PRIOR to
installation of the water lines.
Filter Installation (See Figure 10 & 11):
The Filters inside the Water Dispenser have not been factory installed. They have been
shipped in their original shrink-wrapped packaging for sanitation purposes.
The Filters are located behind the Lower Front Panel of the Dispenser. Follow these steps
to access/install the Filters:
1. Remove the Magnetized Lower Front Panel from the Dispenser (Figure 10).
2. Remove the Filters from the Retaining Clip, and remove the shrink-wrap.
3. Check that the Red Locking Tabs, (Filter Heads) are positioned to the left "Unlock"
position (Figure 11).
4. Insert the Sediment Filter into the Sediment Filter Head (left side), and give it a 1/4
turn clockwise until it stops and the dots are properly aligned. Repeat the same
process for the Carbon Block Filter (right side). Push the Red Locking Tab to the right
"Locked" position (See Fig. 11) for both filters. If the Red Locking Tab fails to engage
(lock), the Filter may not be properly aligned. Make sure the color dots on the filter
head and filter are properly aligned.
NOTE: The internal water connection lines to the Filter Head are factory
installed.
The installation is now complete. Slowly open the Shut-Off Valve. Check all connections
for leaks prior to opening all water valves fully. If any leaks are detected, immediately
turn off the water supply and repair.
Figure 7
Sanitation Plug
Figure 8
Backstop
Full engagement length
Figure 9
Collet
Horseshoe Clip
Figure 10
Figure 11
45˚
O-Ring
1/4
6