Vintec VWUD044BAB Guía De Uso Y Cuidado página 11

CONCRETE FLOOR installation:
A
B
C
3
D
F
1. After you have chosen the installation
location, use either hole (3) to secure
the bracket into the concrete floor.
2. Using a concrete bit, drill 8mm (3/8")
pilot hole 45mm (1.7") deep.
3. Remove the nut, lock washer and
washer from the expansion screw (F).
4. Carefully tap the expansion screw
into the concrete, using a hammer or
mallet.
5. Align bracket hole (3) over the
expansion screw threads and replace
washer (D), lock washer (C) and nut
back on the expansion screw. Fasten
bracket to the floor by tightening nut
securely.
6. Align lower corner of unit and bracket
slot (A), secure with hexagon bolt (B),
lock washer (C) and flat washer (D).
Hexagon Bolt
1/4" x 1.2" (1 pc)
Lock Washer (1 pc)
Flat Washer (1 pc)
Expansion Screw
1/4" x 2.4" (1 pc)
A D
C
B
F
3/8"
Installation
NOTE
If installing on a concrete floor, concrete
fasteners are required, (not included with
the anti-tip kit).
WARNING
TIP OVER HAZARD: One of the rear
cabinet leveling legs must be engaged
under an anti-tip bracket.
WARNING
After installing the bracket, try using light
force to tip the unit. If the unit does not
tip then the bracket is mounted securely.
If the unit does tip, the bracket MUST be
reinstalled following these instructions.
11