Setting The Sensor; Vibration Threshold - FAAC TM2 X W Manual Del Usuario

SETTING THE SENSOR

To associate the sensor to a motor, a remote control must be already memorised
on the motor. The setting sequence is the following:
At this point, do not assemble the sensor shell on the base.
• Insert the batteries provided;
• Open the awning completely (button C);
• Rotate the selector to the 0 position;
Tn: already programmed remote control
C
• Press the buttons on the remote control in this sequence: A+B and B, and then
the SET button for 2 seconds on the TM2 X W sensor; until the motor performs
the confirmation movement (around 2 second).
+
A B
Tn
Note: to check proper memorisation, press the SET button briefly again: the awning
should move about half way through its path. When the check is completed, open
the awning once again.
set

VIBRATION THRESHOLD

The vibration detection threshold is set by choosing one of the positions on the ro-
tating selector, from 1 (light vibrations) to 9 (strong vibrations). The proper threshold
setting for each type of awning must be determined, through trial and error. Start
out by setting a middle value (e.g. 5) and then activate the sensor. After activation
it will be possible to perform tests to find the best threshold.
TM2 X W
B
Tn
21
set
2 sec
A4518_6H02_Rev.A