Replacing The Lamp; Closing The Door; Technical Data - Electrolux A75298-SK1 Manual De Instrucciones

12

Technical data

Problem
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance from the power socket.
2. Press the spring and at the same time pull
the cover downwards.
3. Replace the bulb (E14 socket) with one of
the same power (the maximum power is
shown on the light diffuser).
4. Reconnect the appliance.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Technical data
Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The door has been open to long. Close the door.
The appliance is not levelled.
The appliance is not levelled.
Height
Width
Depth
Solution
Connect another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Replacing the lamp".
Refer to "Levelling".
Refer to "Levelling".
1800 mm
595 mm
600 mm
12 h