Replacing The Lamp; Installation - Electrolux EN3700MFX Manual De Instrucciones

10 www.electrolux.com
Problem
Door does not open easi‐
ly.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

6.2 Replacing the lamp

The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover
with your fingers to unlock it. Remove

7. INSTALLATION

WARNING!
Refer to Safety chapters.
7.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
Possible cause
You attempted to re-open
the door immediately after
closing.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
Solution
Wait a few seconds between
closing and re-opening of the
door.
the cover by pulling it towards
yourself.
2
2. Replace the bulb with one of the
same power and shape, specifically
designed for household appliances.
3. Install the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.
Climate Ambient temperature
class
T +16°C to + 43°C
7.2 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
1
1