Shaft Assembly - Westinghouse LTB40 Manual Del Usuario

ASSEMBLY
INSTALLING THE TRIMMER GUARD
WARNING: Always remove the rechargeable
battery from the device before all work.
Only use trimmer guard sent with tool. If you
need to replace always make sure to use correct
Westinghouse replacement part.
1. Feed the head of the trimmer and line through
the top of the guard hole.
2. Then align the four pins (1) of the protective
cover with the holes of the spool base drum
one-to-one match. Use screws provided to fix
them together.

SHAFT ASSEMBLY

WARNING: Always remove the rechargeable battery from the
device before all work.
Use the guides on the lower and upper shaft to align correctly, then
insert the lower shaft into the shaft coupler on the upper shaft. Hand
tighten the coupler to lock in place.
INSTALLING AND REMOVING THE RECHARGEABLE BATTERY
WARNING: Always switch the tool off before you insert or remove the rechargeable battery.
If you want to remove the rechargeable battery from the tool, press the button on the end of the
battery and pull the it from the tool. To insert the rechargeable
battery in the tool, first line up the base of the rechargeable
battery with the guide on the housing. Then push the
rechargeable battery firmly into the tool until hear the locking click
into place. If the rechargeable battery is not locked into place,
you or other persons may be injured.
CHANGING THE TRIMMER SPOOL
WARNING: Always remove the rechargeable battery from the device before all work.
Press the spool head cap buttons (2) and pull down to remove spool head cap (1). Place new spool
in place, make sure words on spool are facing toward you. Feed trimmer line on each side through
holes in trimmer head (4). Replace spool head cap until it clicks in place.
CAUTION: To avoid trimmer
damage, if the cutting line
protrudes beyond the trimming
blade, cut it off so that it just
reaches the blade.
10