Powermate P-WLE-1639 Manual Del Usuario página 7

Assembly
• Save all instructions
Read and follow the assembly instructions. Do not discard any parts or materials until the unit is assembled.
References to the right or left side of the edger are from the viewpoint of the operator's position behind the edger.
WARNING
Do not operate edger if it is damaged or not completely and correctly assembled.
WARNING
Before doing any assembly or maintenance to the unit, remove the wire from the spark plug.
WARNING
Always wear ANSI compliant safety glasses with side shields while assembling the edger.
The following components will be found in the carton.
Quantities shown in ( ).
1. (1) Edger
2. (1) Edger Operator's Manual
3. (1) Upper Handle
4. (1) Control Rod
5. (1) Bottle of SAE 30 Engine Oil
6. (1) Parts bag containing the following:
(2) Hair Pins
(2) Plastic Wing Nuts (M8)
(2) M8x35mm Pipe Bolts
(1) Wire Tie
(1) Spark plug socket wrench w/ rod
A
How to Remove Edger from Carton
1. Remove all parts and packaging components.
2. Use a utility knife to cut all 4 vertical edges and lay the
side panels flat around the edger.
3. Remove any remaining packaging.
4. Roll the unit out from the carton, and place on a hard
level surface.
B
How to Assemble the Handle
NOTE: Refer to Figure 2 when following steps below:
1. Assemble the upper handle to the lower handle with the
(2) pipe bolts and the (2) plastic wing nuts. Firmly hand-
tighten the wing nuts.
2. Slide one end of the control rod into the hole of the
Depth Control Lever. Secure with hairpin.
3. Slide the other end of the control rod through the hole of
the quill arm. Secure with second hairpin.
4. Attach the recoil starter handle through the rope guide,
by twisting it into position.
5. Remove the temporary insert from the engine flameout
wire terminal.
6. Connect the flameout wires from the engine and handle.
Use cable tie to secure loose wire to handle.
Questions? Call Toll Free at 1-800-737-2112
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
WARNING
DANGER
Flameout wires MUST be connected for correct engine
operation. Failure to connect can result in serious injury.
Upper
Handle
Handle
Flameout
Wire
Recoil
Connection
Starter
Terminal
Handle
Engine
Flameout
Wire
Plastic
Wing Nut
Lower
Handle
Copyright © 2008 MAT Engine Technologies, LLC
6
Hair Pin
Depth Control
Lever
Control Rod
Quill Support
Arm
Pipe
Bolt
Hair Pin
Figure 2