D-Link DWR-953 Guía De Instalación Rápida página 5

TrOuBlESHOOTING
seTuP AND CoNFiGurATioN ProBleMs
1. HOW DO I CONFIGurE MY DWr-953 rOuTEr Or CHECK MY WIrElESS NETWOrK NAME (SSID)
AND WIrElESS ENCrYPTION KEY?
• Connect your PC to the router using an Ethernet cable.
• Open a web browser and enter the router's IP address: http://192.168.1.1
• Log into the router using the default username admin; leave the password area blank.
• Once logged in, you can use the wizard located under Internet settings to configure the router,
or make changes manually.
Note: If you have changed the password and cannot remember it, you will need to reset the
router to factory defaults.
2. HOW DO I rESET MY DWr-953 rOuTEr TO FACTOrY DEFAulT SETTINGS?
• If you cannot remember your router administrator password, you may use a paperclip to press
and hold the reset button on the front of the router for about 10 seconds.
Note: Resetting the router to factory default will erase the current configuration. To reconfigure
your router, log in as outlined in question 1, then run the Setup Wizard.
3. HOW DO I ADD A NEW WIrElESS DEVICE Or PC IF I HAVE FOrGOTTEN MY WIrElESS
NETWOrK NAME (SSID) Or WIrElESS ENCrYPTION KEY?
• Every device that needs to connect to the router wirelessly will need use the correct Wireless
Network Name (SSID) and encryption key.
• Use the web-based user interface (as described in question 1 above) to check or choose your
wireless settings.
• Make sure you write down these settings so that you can enter them into each wirelessly-
connected PC. You will find a dedicated area on the back of this document to note this important
information down for future use.
4. WHY AM I uNABlE TO ESTABlISH AN INTErNET CONNECTION?
• If connecting using a 4G mobile connection, make sure that you are within range of the mobile
service provider, and that the service has been correctly configured.
• If connecting using the WAN via ADSL/Cable service, make sure the modem has been enabled/
connected and is operational, and that the service is correctly configured.
DWr-953
3