Mesko MS 2826 Manual De Uso página 4

because water proximity presents risk, even if the device is turned off.
17. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. The cutting scissors are very sharp. Use caution when assembling, dismantling and
cleaning. Do not touch any elements of the moving blade during the operation!
23. Do not use the device for more than 10 minutes at a time. After 10 minutes have
elapsed, turn it off for approximately 5 minutes. DO NOT CHARGE THE BATTERY FOR
LONGER THAN 8 HOURS – this can cause irreversible damage to the battery.
24. The charging process should be conducted in temperatures between 5-35 degrees
Celsius.
25. Do not wash the blades in water.
26. Only change comb attachments when the trimmer is switched off.
PRODUCT DESCRIPTION (FIG. 1)
1. 'On/off' button
2. Scale of regulation of cutting length
3. Charging indicator
CHARGING THE BATTERY
Charge the battery before use. To begin charging plug the power cord into the trimmer's socket, and the charger into a mains power
outlet. The charging indicator will light up (fig. 1.4). The light will remain on until the device is unplugged from mains power. The first
charge takes 8 hours; subsequent ones should last 4 hours. A fully-charged battery lasts for approximately 90 minutes of continuous use.
After charging, unplug the charger from the socket. If the trimmer is not used for a long period of time, it should be charged at least once
every 6 months. In order to maintain adequate battery capacity. If the battery is empty, you can continue cutting using the charger. To do
this plug the charger cable into the trimmer socket. After 2 minutes you can continue cutting.
USING THE TRIMMER
Select the desired cutting length by change the comb (fig. 1.2), observing the regulation scale (fig. 1.3). Start cutting by running the
trimmer with the comb attachment against the direction of hair growth. This should be done slowly and at a steady speed. Please
remember to regularly clean the trimmer and cutting head of any hair.
CLEANING
Unplug the device from the power source. Remove the cutting head (fig. 2). Clean the blade with the included brush. No hair should
remain between the blades after cleaning. Every few haircuts lubricate the cutting head by dropping 2-3 drops of the machine oil into the
space shown in fig. 5. Close the head (fig. 3). Clean the casing with a dry or slightly damp cloth.
TECHNICAL INFORMATION
Power supply: 100-240V~ 50/60Hz
Charging time: 4 hours
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding
waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous
components, which may effect the environment. Do not dispose this appliance in the common waste bin.
DEUTSCH
4