Philips HF3520 Manual De Usuario página 7

Problem
The radio produces a
crackling sound.
The alarm went off
yesterday, but it did not
go off today.
I wanted to snooze, but
the alarm did not go off
again after 9 minutes.
The light wakes me too
early.
The light wakes me too
late.
The lamp flashes.
Solution
Perhaps the broadcast signal is weak. Adjust the frequency (see user
manual for more information) and/or change the position of the
antenna by moving it around. Make sure you have unwound the
antenna completely.
Perhaps you switched off the alarm function.The alarm icon is visible
on the display when the alarm function is active.
Perhaps you set a volume level and/or light intensity level that is
too low. Set a higher volume level and/or light intensity level in
your wake-up profile (see user manual for more information).
Perhaps there was a power failure. In this case, the appliance goes
back to factory settings. You need to set all functions again.
To snooze the alarm, press the SNOOZE button (HF3510 only) or
tap on the front of the Wake-up Light (HF3520 only). If you press the
alarm button, the FM button, or the MENU button, the alarm function
will be deactivated.
Perhaps the light intensity level you have set is not appropriate for you.
Try a lower light intensity level if you wake up too early. If light intensity
1 is not low enough, move the appliance further away from the bed.
Perhaps the appliance is positioned at a lower level than your head.
Make sure the appliance is located at a height at which the light is not
blocked by your bed, duvet or pillow. Also make sure the appliance is
not placed too far away.
Perhaps the appliance is not suitable for the voltage to which it is
connected. Make sure that the voltage indicated on the appliance
corresponds to the local mains voltage.
EnglIsH
7