Leviton omnistat 3 Instrucciones De Instalación página 5

MOUNTING
When mounting the RC500-2EW, grasp the thermostat by
the sides and unsnap the base from the face.
Holding the base to the wall so that the word "UP" is upright
and facing you:
1. Mark the two mounting holes on the wall using a pencil.
2. Drill a hole using a 3/16" bit at each mounting hole marking.
3. Install the two wall anchors supplied.
4. Slide the system wires through the opening in the base.
5. Mount the base to the wall using the two #6 x 1" self-
tapping screws supplied - See Figure 1.
Connect each wire to the terminal strip(s) on the thermostat
base per the wiring diagram for your system application -
See Figures 4 - 11. Form the thermostat wiring so that the
cable lies flat between the terminal strip(s) and the center
of the base - See Figure 2.
Upon completion of wiring the thermostat, push all excess wiring into the hole in the
wall. For best performance, Leviton recommends plugging the hole to ensure an
accurate temperature reading by the thermostat.
Align the tabs of the thermostat face with the slots of the thermostat base. Gently push
the thermostat face into the thermostat base locking it into place - See Figure 2.
NOTE: Be sure that the thermostat temperature sensor is standing up, and that it has not
been damaged during installation - See Figure 3.
Figure 2
Figure 1
Figure 3
Wall
Slot Tab
Temperature
Base Sensor
3