Steering Control Levers; Park Brake; Ignition Switch - Husqvarna Z 254 Manual Del Operador

Steering Control Levers

The machine's speed and direction are continuously variable
using the two steering controls. The steering controls can
be moved forward or backward about a neutral position.
Furthermore, there is a neutral position, which is locked if the
steering controls are moved outward.
When both controls are in the neutral position (N), the machine
stands still.
By moving both controls an equal amount forward or
backward, the machine moves in a straight line forward or
backward respectively.
In order, for example, to turn right while moving forward, move
the right control towards the neutral position. The rotation of the
right wheel is reduced and the machine turns to the right.
Zero turn can be achieved by moving one control backward
(behind the neutral position) and carefully moving the other
steering control forward from its neutral position. The rotation
direction when zero turning is determined by which steering
control is moved backward behind the neutral position. If the
left steering control is pulled backward, the machine turns to
the left. Use extra care when using this maneuver.
If the steering controls are in uneven positions when standing
still or do not fit in the slots for moving the controls outward,
they can be adjusted.
CONTROLS
WARNING! The machine can turn very rapidly if one
steering control is moved much further forward than the
other.

Park Brake

The park brake is integrated with the steering control levers.
Move both levers outward from the neutral position to engage
the park brake.
To release the park brake, simultaneously rotate both steering
control levers inwards to the neutral position. Do not attempt
to operate the unit without both levers being inwards out of the
engaged position or machine components could be damaged.
IMPORTANT INFORMATION Failure to bring the steering
control levers inward simultaneously will cause the unit's
safety system to shut the unit down.

Ignition Switch

The ignition switch is placed on the control panel and is used
to start and stop the engine.
12