Husqvarna Z 254 Manual Del Operador página 17

4. Move the steering / park brake controls firmly out to the
locked position.
5. Move the throttle lever to the full throttle position.
NOTE: There is a detent at the full throttle position to aid in
setting the control.
If the temperature is below 32
up to the cold weather (snowflake) starting position.
When the engine has started, move the throttle lever back
to full throttle detent and allow the engine to warm up for a
short period before operating the unit. Failure to move the
throttle from the cold weather starting position will result in
poor engine performance, smoke and spark plug fouling.
WARNING! Make sure that no one is near mower
when engaging blade switch.
Make sure the work area is free from objects that could be
thrown by the rotating blades.
OPERATION
F, move the throttle lever
O
6. Press in and turn the ignition key to the start position.
7. When the engine starts, immediately release the ignition
key back to the run position.
IMPORTANT INFORMATION Do not run the starter for
more than 5 seconds each time. If the engine does not
start, wait approximately 10 seconds before retrying.
8. Set the engine speed with the throttle. Allow the engine to
run at a moderate speed, approximately mid throttle, for a
short time before use.
9. USE FULL THROTTLE WHEN MOWING.
Running
1. Release the park brake by simultaneously pulling the
steering / park brake controls inwards to the neutral
position.
NOTE: The mower is equipped with an operator presence
system. When the engine is running, any attempt by the
operator to leave the seat without first setting the park
brake will shut off the engine.
17